Heat Exchanger

1549 Highway 36 N

Rosenberg TX 77471

Phone (281) 342-8775

Toll Free 1-866-808-8827

Fax (281) 342-8756

E-mail: spa2bath@yahoo.com

Hours: Mon-Fri: 8:30am - 5:00pm

Sat: 9:00am - 3:00pm

Whirlpool tubs that are equipped with a Recycling System circulate a small amount of water through the

Jacket. The water that is circulated through it collects the heat (energy) produced by the electric motor and

transfers the heat to the tub of water. The Heat Recycling System is designed to compensate for the heat loss

caused by the whirlpool jet's air actions. If during prolonged use the water temperture exceeds the desired temperature, you may lower the temperature by opening the venture air valve control or by adding cooler water from the supply faucet.

Warning: The Heat Recycling can generate water temperatures higher than recommended bather use of 104 degrees farenheit. When installing this device on a hot tub or spa the system pump motor must be themostatically controlled.

"Thermal Wrap"

Heat Transfer System

Superior Quality and Value

The Original Heat Transfer System

For Whirlpool Baths and Spas

Bath Water Temperature Graph

Safe...

Economical...

Efficient...

* Manufactured with non-conductive materials.

* Non-electrical - no additional electrical circuits

  required for installation.

* Self-draining design.

* UL recognized heaters.

* Maintenance free - no moving parts to wear out.

* Helps keep motor cooler increasing its longevity and        efficiency.

* Costs less than electric heaters.   

* Thoroughly tested, patented            design, nearly 300,00 in use.

With Thermal Wrap water stays hot

MINUTES/HOURS

Temperatures are approximate and may vary according to motor make and operating conditions.

OPERATING INSTRUCTIONS

Water circulates through Jacket collecting heat generated by pump motor.

The Heat Recycling System has been designed for use with Hydrotherapy bath tubs and spas.

Manufactured and marketed under the following U. S. Patents

4854373, 5038853,5509463