Standard Whirlpool Equipment
69" length x 69" x width x 23 3/8"
7 multi-directional jets
2 air controls
1 safety suction
1 pneumatic air switch
1 HP pump/motor with 3 foot cord
NOTE: Dimensions are +/- 3/8" and are subject to change without notice. Final installation measurements should be taken directly from your bathtub. All bathtubs are water-tested for leaks and proper operation before leaving the factory. However, since damage may occur during transportation, installer should test for leaks, proper operation, and insure that the air line is connected from the equipment to the on/off switch before closing in the bathtub.
Plumbing and electrical codes require an access to be provided by the installer for servicing the pump/blower.
Pump: Premounted 1 HP / 115 V / 20 amp, GFCI-protected circuit
Blower: Premounted 1 HP / 115 V / 15 amp, GFCI-protected circuit
For Technical info click here.
not to scale.
* measurement does not include headrest.
1549 Highway 36 N
Rosenberg TX 77471
Phone (281) 342-8775
Toll Free 1-866-808-8827
Hours: Mon-Fri: 8:00am - 4:00pm
Minimum w/pool volume 47 gallons Maximum tub-only volume 72 gallons
Whirlpool weight 127 pounds
Against the wall (may require added tile flange.)
Recessed in platform
Specify right or left pump
Specify right or left drain
Soaking tub (No jets)
Air bath (add 1 " to overall height)
Whirlpool & Air Bath Combination ( add 1" to overall height,equipment may extend past tub)